The Pro Banner Saver brackets are easy to install, move and adjust.
These step by step instructions will guide any installer on how to install the perfect light pole banner.
We recommend a Top Down approach when installing the brackets and recommend you install the banner at the same time. This is to avoid any readjustments which may be required due to improper measurements.
What you will need to complete the install
- Cordless Screw Driver & correct drill bit
- Tin Snips & Plastic Snips
- Bungee Cord (size depends on pole size)
- Neoprene Protective Sheet (if needed)
- Pro Banner Saver Brackets (2 per banner)
- Banding (3 per bracket)
- Zip Ties / Cable Ties (2 per banner)
- Lift Truck / Ladder
Steps to install
Installing the Top Bracket
Top bracket, spring on top
- Measure the height for the top bracket and position the bracket.
- Wrap a bungee cord through the centre and clasp so bracket stays in position
- Install the 3 bands – 2 on top & 1 bottom & Snip of the excess bands (only snip bands if it is a permanent install.
Installing the Banner
- Fiberglass pole needs to be at least 4” longer than the banner width
- Insert pole through banner pocket and insert end with the metal sleeve into the mouth of the bracket
- Twist the fiberglass pole to align the holes in the pole to the one on the side of the mouth on the bracket
- Insert Pin through side of the mouth and fiberglass arm and secure it.
- Finish with zip tie through grommet and the loop on the safety pin
- Clip the excess of the zip tie
Installing the Bottom Bracket
- Repeat steps 5 – 7 with the bottom of the banner
- Extended the banner fully with the bottom bracket inserted.
- Push the bracket on the pole and Install the bottom bracket using steps 2, except 2 bands go on bottom and 1 band on the top.
- Finish with zip tie through grommet and trim ends of the zip tie.
Make Sure:
- The brackets and fiberglass poles align vertically
- The tension runs through the centre of the banner
If not then adjust up or down to achieve the desired result.
Maintenance
The Pro BannerSaver brackets will work well for many years, increasing banner life and reducing street light pole damages, but maintenance is crucial and we recommend that you Re tighten the banding approx 2-4weeks after initial installation if necessary.
Bolting and Wall Mount Installations
- The Pro BannerSaver can be installed on walls via a bolt instead of banding.
- We recommend a 3/8” Bolt size for the Pro BannerSaver Brackets install.
- Wall Mounts: The Pro BannerSaver will spill wind regardless of its mounting on a pole or wall. The customer is responsible for all wall mounted installations, and warranties do not apply due to the wide variation in walls
Banding and Other Considerations
Neoprene Sheet: When is this recommended?
The Pro BannerSaver brackets will work well for many years, increasing banner life and reducing street light pole damages, but maintenance is crucial and we recommend that you Re tighten the banding approx 2-4weeks after initial installation if necessary.
Pro Banner Saver is the Most Advanced Wind Releasing Banner System
It has the best specs, features and quality compared to anything else on the market!
